• NewFC is now officially an archive. Please go to FuckCombustion for more information. If you have an account there, use it. If you changed your account name when you registered here, use your FC account. If you did not have an FC account, please register one. Thanks to everyone for their patience.

7thFloor LSV (Life Saber Vaporizer)

blissfulyogi

Member
Messages
33
Check out my photo. I bought my unit used. I spent a lot of time on the old FC and found that pulling the heater unit it out slowly and carefully (when the device is off obviously) to show the "std" from picture can enhance vapor production at lower temps. It worked well for me. It did take some trial and error to get the temp set right. Also some changes in my draw speed. Starting slower and finishing faster.

I also use the standard 18 mm joint with a half basket screen. I chose this over the circle joint because I have so many other devices that use this joint, it made more pieces interchangeable. I usually only stir once, and sometimes I just push the material around a bit with my finger and that is enough to change the air path and allow for the rest of the material to be vaped.
Hi thank you for the photo, so that is the exact position to keep it, mine kind of slided back when I pull it up but now it seems to stay right in the zone where the - is. About the dialing the temp, do you mean that every LSV is different or that every user should find their suitable temp.
Do you mean this joint ? half baskets are these ?


21 inches,isopropyl for 100$ and it is indeed a std mark but not a boil or lesion.
No basket screen and I do stir.
However as I said the stempod is the same only betterer.
what do you mean by 21 inch and iso for 100? your rig that you use with LSV and clean with iso ? I apologize for lack of knowledge, Im kind of new in this thread lol
 
blissfulyogi,
  • Like
Reactions: rebar

rebar

Well-known Member
Messages
71
Location
Montana
That piece is 21 inches tall.
That jar is full of dirty iso.
That is a half basket screen in your pic.
That is a male to male adapter in your pic.
I place a screen down inside the male to male they have a lip around the base of the grind on the inside that the screen sits flat down on top of.
The two options are essentially big bowl,small bowl.
The ceramic heating rod can slide some in the units try gently twisting it a bit.
Finally the dial pops off.
I find if I have off at 6 then I use at 12 to be consistent across four different lsv units.
Finally elev8 makes a water pipe adapter in both tall and short.
I think they suck maybe you will have better experience,idk.

Are you really saying that a Stempod is a better vape than an LSV? How so/in what way?
Portability..........exactly alike function wise.
All four lsv's have been in a drawer for three months now,that says it all for me.
Never gets hot,no glass to break I can rebuild it entirely.
Costs way less up front and I find the company much better to deal with.
510 has changed the game completely for me.
 

blissfulyogi

Member
Messages
33
That piece is 21 inches tall.
That jar is full of dirty iso.
That is a half basket screen in your pic.
That is a male to male adapter in your pic.
I place a screen down inside the male to male they have a lip around the base of the grind on the inside that the screen sits flat down on top of.
The two options are essentially big bowl,small bowl.
The ceramic heating rod can slide some in the units try gently twisting it a bit.
Finally the dial pops off.
I find if I have off at 6 then I use at 12 to be consistent across four different lsv units.
Finally elev8 makes a water pipe adapter in both tall and short.
I think they suck maybe you will have better experience,idk.
What are your plans with that dirty iso ? I evaporated mine couple times but it still have this distinct smell, kind of sweet smell, cant really descibre it but my unused iso smell the same. Thank you for the tips , do people have better success with longer bowls or half bowls? The M to M 18mm should be sufficient enough for it , Im wondering if I should get some kind of stem or something similar for the replacement of the shattered long wand. By the lip in the 18mm joint you mean basically the area in the middle right ? nice piece but if it was reply adressed to that mineral, I meant the, you know the stone on your desk lol :D :D
 
blissfulyogi,
  • Like
Reactions: rebar

howie105

New Member
Messages
4
so you load the basket screen directly? ... Yes I do, just suck up the bud directly into the basket and tamp.

I thought from the image posted previously that you create a little chamber , fill it up normally and tamp it and then cover it with the basket screen. ... Its preference, I don't like to stir, so I usually go for smaller loads that I can clean in a hit or two.

Is LSV a vape that you can vape full load on one inhale ? or is it like providing generous hits? Either way works for me, its just dependent on how much I want to load and how much stirring I am willing to do.
 
howie105,
  • Like
Reactions: rebar

rebar

Well-known Member
Messages
71
Location
Montana
What are your plans with that dirty iso ? I evaporated mine couple times but it still have this distinct smell, kind of sweet smell, cant really descibre it but my unused iso smell the same. Thank you for the tips , do people have better success with longer bowls or half bowls? The M to M 18mm should be sufficient enough for it , Im wondering if I should get some kind of stem or something similar for the replacement of the shattered long wand. By the lip in the 18mm joint you mean basically the area in the middle right ? nice piece but if it was reply adressed to that mineral, I meant the, you know the stone on your desk lol :D :D
I dump it out in the dirt when it is too gross anymore.
I fill the chamber 2/3 full not packed right though.
This stem works for the lsv also.
Dhgate 3 for 20$ if I remember right.IMG_20200609_091844.jpg
 

blissfulyogi

Member
Messages
33
I dump it out in the dirt when it is too gross anymore.
I fill the chamber 2/3 full not packed right though.
This stem works for the lsv also.
Dhgate 3 for 20$ if I remember right.View attachment 1336
damn thats a good one for 20 I remember snatching matrix perc ion sidekick for 25-27bucks, great buy too.
Does your iso have any smell before usage? like little sweet, hairspray smell?
 
blissfulyogi,

rebar

Well-known Member
Messages
71
Location
Montana
damn thats a good one for 20 I remember snatching matrix perc ion sidekick for 25-27bucks, great buy too.
Does your iso have any smell before usage? like little sweet, hairspray smell?
Just smells like alcohol,are you using denatured alcohol?
That stuff has a sweet smell but is toxic.
 
rebar,

blissfulyogi

Member
Messages
33
Just smells like alcohol,are you using denatured alcohol?
That stuff has a sweet smell but is toxic.
It was sold to me as an iso for pc parts etc. not sure , but I can certainly say that the smell lingers in the reclaim even when evaporated to the max. I hope I did not poisoned myself all this time, can that sweetness compare to subtle hair spray smell?
 
blissfulyogi,

rebar

Well-known Member
Messages
71
Location
Montana
Isopropyl should smell like alcohol and nothing else and should evaporate and be odorless.
 
rebar,

blissfulyogi

Member
Messages
33
Isopropyl should smell like alcohol and nothing else and should evaporate and be odorless.
I had a pleasure to smell denaturized alc and it smell awfully similar to my iso, so I got scammed. I will buy iso elsewhere to compare it
 
blissfulyogi,
  • Like
Reactions: rebar

nonamekevin

Member
Messages
26

Really tempted at this price.
 
nonamekevin,
  • Like
Reactions: Ramahs

rebar

Well-known Member
Messages
71
Location
Montana

Really tempted at this price.
I saw that then saw this a while ago.
Made me a bit leary let us know how it goes it you do.
Puffitup.com with code puffedup is a decent price.
 
rebar,

nonamekevin

Member
Messages
26
I saw that then saw this a while ago.
Made me a bit leary let us know how it goes it you do.
Puffitup.com with code puffedup is a decent price.
That's vaping.com though, not vaped.com. Unless they are the same company? :shrug:
 
nonamekevin,
  • Like
Reactions: rebar

Abcd5432

Active Member
Messages
44
I had a dabuddha, sold it to a friend. But they didn't take care of it well sadly. How does this compare?

To the newvape? Everyone loves the new vape, but I did like my dabuddha.

This looks interesting for a SAFE relatively stationary vape that you don't need to worry about batteries.

I honestly left my dabuddha on a bunch of times for a long time.
 
Abcd5432,
Top Bottom