• NewFC is now officially an archive. Please go to FuckCombustion for more information. If you have an account there, use it. If you changed your account name when you registered here, use your FC account. If you did not have an FC account, please register one. Thanks to everyone for their patience.

Multi-brand Healthy Rips Fury

OF!

Member
Messages
23
even keep the stems, although I'm honestly not sure why.
Understood. It's in our genetics I think. Time was 'lids' came complete with seeds as well. We'd save them too even though they with the stems contained a small fraction of the THC from what was by today's standards very weak pot. I used to keep mine in the shoebox lid I'd 'roll' the weed down to separate the round seeds out of (holding it at a slant and scooping up with a matchbook or rolling paper cover). The top and a jar with the stems lived in my coffee table for the next time we 'scored'. I had a friend who would fuss over the residual for a while and always manage to find enough 'dust' to roll at least a pinner for us. Talented guy, but a skill sadly out of date.

"Down to seeds and stems, again". Worlds saddest song (30 years later):

OF
 
OF!,

Moses Baca

Well-known Member
Messages
34
Anyone else have issues with how the mouthpiece snaps on?

I used my F2 daily for quite awhile, it was my commuter vape. After a year or so I noticed that the original mp would pop off the unit very easily. I assumed it was getting a bit worn so I bought a POTV One glass mp as a replacement but it didn't work. POTV was nice enough to send me a second glass mp to try but it didn't work, either. Next I bought an original replacement mp direct from HR but it just pops off, same as all the others.

Any suggestions? It's been thoroughly cleaned multiple times. I'm beyond my 1 year warranty. HR has a lifetime 50% replacement so maybe I'll have to exchange it? Electronically it works fine. I just can't get a mouthpiece to stay attached, I have to physically hold it in place. :(
 
Moses Baca,
  • Like
Reactions: Vaporific

Vaporific

Well-known Member
Messages
73
Anyone else have issues with how the mouthpiece snaps on?
Hey there - yes. Kinda. I bought a new Snap (Fury clone) at a freedom festival just 30 minutes after my only Grasshopper died. Granted it’s not a Fury but the same thing happened about 4 months later and I had no recourse or trying to track down the vendor. I tried everything from ISO soaks, toothpicks along corners and contours on both the mouthpiece and body (which was gently rubbed with QTips with ISO) but it doesn’t stay on much any longer. I’ve sat and stared at this from so many angles and fail to see the reason. So I bought a new Fury 2 to rectify things :D. It hasn’t let me down yet - mouthpiece, heater, battery (still not too bad), display. Great little portable vape.

And yes my F2 mouthpiece doesn’t stay on the Snap well either. So we have the body potentially being a common culprit. I relegate the Snap to home use only and seldom use it anyway because of the F2.

Hope you find a solution. Electrical or duct tape might work. Seriously. I haven’t tried but it might. Someone suggested to
me using a Fury protective cover and carefully cut a hole at the top. I never tried that either but it could work. At least with HR, whom I’ve emailed with on several occasions, they have great CS and can offer suggestions. :peace:
 
Top Bottom