• NewFC is now officially an archive. Please go to FuckCombustion for more information. If you have an account there, use it. If you changed your account name when you registered here, use your FC account. If you did not have an FC account, please register one. Thanks to everyone for their patience.

RBT Open Source

unklmark

Active Member
Messages
18
IMG_20200617_163415934.jpgIMG_20200617_165349580.jpgLet the first Instagram auction begin!!! One of a kind 2 wood,Purpleheart and Wenge,
Vapor Lighter Z (check the resistance), with matching 2 wood bowl.......Bidding starts at $150.... I have a brand new P80 in bronze/copper....I'll install firmware and dial in TCR, just add $50 to the final bid.....I'll let it go for a couple days, or until it's obvious the auction is over.... Gallery-
 
Last edited:

Shit Snacks

Milaana. Lana. LANA. LAANAAAAAAA
Messages
237
Wow that is gorgeous @unklmark!

My custom redheart wood pick arrived today, such beautiful grain and color, here it is on my walnut Milaana 2 with sapele bottom cap (first with flash then without) though these photos cannot do justice to it of course:





Whoever wins that auction is going to be very lucky indeed, thanks again Mark!!
 
Last edited:

Rastabuddhatao

Well-known Member
Manufacturer
Messages
30
Hey folks... the maker videos have been uploaded the the RBT YouTube. These videos contain all the info needed to be an RBT maker other than technical specs on the parts when available in several months.

Videos post include: Heater, glass, wood, assembly tools, Zion, Milaana and Splinter fabrication. Within these videos is all the secrets and details of the 19 mm glass products. With these videos RBT has sunset the 19 mm designs and leaves it in the capable hands of @unklmark and @Khelek41girl and all the makers who share communally here on the #rbtopenspurce.

With that RBT is off to usher in a the exciting new products coming down the pike. Good luck to all you makers!
 

jagi

New Member
Messages
23
But it's possible to pertecipate to this open source project or i understand/don't read enough ?
 

DocAnchovy

🐟
Messages
61
Hello #rbtopensource fam, I’ve been sitting on my kit trying to decide which direction to mod it... and measured out the dimensions to better help picture what would fit. (Currently working the idea of halogen, but I’ll post once further in). Here’s the rough (within 0.1mm) measurements of the z body - Grids are 5x5mm). Hope this is Useful. (I realized halfway through sketch it was upside down...but maybe it’s right side up now. Hmm.. :science: )6E9AC512-6353-4506-9AE0-B2AB7D16D9DA.jpeg
 

DocAnchovy

🐟
Messages
61
Anyone know how long the epoxy needs to cure before it is “safe” to use?
Someone can correct me based on this use case, and I can only speak for the gorilla glue 2 part epoxy. it is fairly quick (I think 2 hours). The label in bold states to “leave for 24 hours for heavy loads.” I think 12+ hours is fine, with 24 being 100% (adjusted for thickness of epoxy applied)
 
Top Bottom